(1)INCLUDES: Electric Valve-Sending Unit-Mounting Hardware Kit.
(2)INCLUDES: Sending Unit-Mounting Hardware Kit.
(3)INCLUDES: Mounting Hardware-Guage Modification Material Kit.
(4)INCLUDES: Electric Valve-Mounting Hardware Kit.
(5)INCLUDES: Electric Valve-Sending Unit-Mounting Hardware Kit.
(6)INCLUDES: Electric Valve-Sending Unit-Mounting Hardware Kit
and Spare Tire Mounts Back Under Tank.
(8)INCLUDES: Electric Transfer Fuel Pump-Sending Unit-Mounting
Hardware Kit.
(9)INCLUDES: Special Tap-in Fittings-Mounting Hardware Kit.
(10)INCLUDES: Sending Unit, In-Tank Electric Fuel Pump Adapter
Plate and Mounting Hardware Kit.
(11)INCLUDES: Electric Transfer Fuel Pump and Mounting Hardware
Kit.
(12)INCLUDES: Electric Transfer Fuel Pump-Sending Unit-Mounting
Hardware Kit.
(13)INCLUDES: Electric Valve-Fuel Guage-Sending Unit-Mounting
Hardware Kit.

ABBREVIATIONS & DEFINITIONS:

SWB = Short Wheel BaseS.O. = Special Order
LWB = Long Wheel Base2 & 4 W Dr. = 2 & 4 Wheel Drive
Aux. = Auxiliary

TERMS:

Gravity Feed:
Any of our fuel tanks which are referred to as "gravity feed" in simplified terms means that the auxiliary (or additional) tank is mounted in a higher position than the stock tank which allows the fuel to be gravity fed or flowed into the stock tank. The stock fuel guage in the vehicle will remain constantly full until the auxiliary tank has completely emptied at which time the stock tank will start to register as usual. Gravity Feed Tanks Not Legal For Sale Or Use In California On Any Pollution Controlled Motor Vehicle.

Van Interior:
Interior modifications may be necessary for the installation of auxiliary fillnecks on some vans.

Side Fill:
All auxiliary fillnecks unless other wise speciafied will be routed through the side of the fender by use of a rubber grommet.

ASTERISK DEFINITIONS:

*AMC-1, DPR-1, CLR-2: These tanks are not baffled - would not allow
adequate clearance for sending unit.

*CPR-1: If equipped with dual exhaust, custom exhaust modifications is
required.
*FPA-5: Mounting brackets are welded on the sides of the tank.
*DPR-1: Mounting brackets are welded on the sides of the tank.
*DPR-4: Mounting brackets are welded on the sides of the tank.
*TLCA-1: All 1970 - 1980 models require custom exhaust modification.

NOTE:

In order to comply with regulations set forth by Federal and State
Agencies, it is the customer's responsibility to specify as to what
type of filler neck be supplied (leaded or unleaded) when placing
an order of auxiliary fuel tank for installation or resale.

SPECIAL ORDER (s.o.):

These tanks are available on a special order basis and will normally
require 3 weeks lead time.